General Features

This is a simple and inexpensive range of ball transfer units which have a large ball exposure. They are ideal for lighter duties and where there is a cost consideration. All units are fitted with a seal which simply and effectively removes debris by an internal plastic scaper. For normal applicatins steel bearings with zinc plated pressings and components are recommended. However, when used as a castor or in wet conditions, stainless steel is recommended.

1700

1701 Bolt Fixing

Features: Plain body, dirt exit hole standard.

Features: Drill hole nut and bolt fixing. Maximum tightening torque is 15Nm.

1702 Flange Fixing

1703 Plate Fixing

Features: Low profile flange fixing, dirt exit hole standard

Features: High profile base plate fixing. Drill hole fixing. Dirt exit hole standard.

1709 Grip Neck Fixing

Features: Plastic or steel socket fixing.

1705 Grip Neck

1707 Round Plastic Splined Socket

Toothed Steel Socket 19 mm Head dia For 9.5mm dia x 35mm deep drilled hole.
Application: Wood

Two sizes available. Tube 15.8 mm O/D x 1.2mm wall thickness 19.0mm O/D x 1.2 up to 1.6 mm wall thickness.
Application: Round Section Tube

1708 Square Plastic Splined Socket

Two sizes available 19mm A/F square x 1.2mm up to 1.6mm wall thickness 25.4mm A/F square x 1.2mm up to 1.6mm wall thickness.
Application: Square Section Tube